NR200P addaptation for RTX 3080 in 🖥️ Tower Mods Posted December 31, 2020 On 12/22/2020 at 4:35 AM, Andrey Bukhtiyarov said: I tried 20mm and 25mm, thos heights displace PSU holder a little to front and cables from PSU became to close to front glass window. So, I selected height only 15mm. Thanks for the explanation. I started receiving parts and began putting them together. The two things that worries me the most are the clearance for AIO cooler and RAM. The Z53 AIO that I have is quite thick with 52.4mm water block height and 30mm radiator height. I did a test fit and was able to stuck that in between the PSU holder and case. The side touching PSU holder cannot fit with protruding screws, so I left that unscrewed. I'm still looking into ways to secure the AIO cooler similar to yours. I was able to close the top panel without cutting the extra plastics for included fans, but I might remove them purely for aesthetics. Once my motherboard arrives, I will report further results later.