NR200P addaptation for RTX 3080 in 🖥️ Tower Mods Posted June 28 On 1/1/2021 at 4:24 AM, Xing said: Thanks for the explanation. I started receiving parts and began putting them together. The two things that worries me the most are the clearance for AIO cooler and RAM. The Z53 AIO that I have is quite thick with 52.4mm water block height and 30mm radiator height. I did a test fit and was able to stuck that in between the PSU holder and case. The side touching PSU holder cannot fit with protruding screws, so I left that unscrewed. I'm still looking into ways to secure the AIO cooler similar to yours. I was able to close the top panel without cutting the extra plastics for included fans, but I might remove them purely for aesthetics. Once my motherboard arrives, I will report further results later. Good day! Sorry for asking but I was just curious about your build. We have the same aio and I was also planning on doing this mod. Did you get around finishing it? Did the z53 fit inside the case? Hoping to get a response from you. Thanks!