Inony Posted January 28, 2021 Author Share Posted January 28, 2021 When everything is fine, install the front panel next. After that, put the rest of the light boxes to install and test to make sure everything is fine. Link to comment Share on other sites More sharing options...
Inony Posted January 28, 2021 Author Share Posted January 28, 2021 The next step is to complete the installation of the hydraulic model. All the shock absorbers I designed are separate and can slide a little. Link to comment Share on other sites More sharing options...
Inony Posted January 28, 2021 Author Share Posted January 28, 2021 After that, the next step is to install the PSU in the designed location. And take the final gear set to install in the designed position. This group is magnetic and has a socket support. it can be easily removed in - out When replacing PSU or cable management. Link to comment Share on other sites More sharing options...
Inony Posted January 28, 2021 Author Share Posted January 28, 2021 After that, the body shell was installed. This shell at the bottom Can slide down a little for open the Back I / O connector on the back of the motherboard. I'll show you in the video that I'll upload when it's finished. Link to comment Share on other sites More sharing options...
Inony Posted January 28, 2021 Author Share Posted January 28, 2021 The next step is to assemble the front door. Let's try to make sure everything goes smoothly. And it can be completely articulated. Bring the acrylic sheet to heat bending. And fixed. There are four magnetic sockets at this point on the main structure. And now everything is fine. Link to comment Share on other sites More sharing options...
Inony Posted January 31, 2021 Author Share Posted January 31, 2021 When the torso is completed, then the shoulder. At this point, I designed it to accommodate a 120 mm radiator. But the hardware that I installed, I only use AIO, so I installed just a fan for beauty. No need to add more radiator After that, the part of the door was attached together. I used 4 magnets on each side to hold. Link to comment Share on other sites More sharing options...
Inony Posted January 31, 2021 Author Share Posted January 31, 2021 Bring both shoulders and attach them to the body part. To install the main hardware built-in When the hardware is installed, I run the test once to make sure everything is fine. Link to comment Share on other sites More sharing options...
Inony Posted January 31, 2021 Author Share Posted January 31, 2021 The next part is the body. Which has no hardware, but must be installed In order not to turn my work into a headless. I used a magnet to install it to make it easier to service the LED. Test the light for once. To take a picture for the forum update and then mount it on the base. I made it separate. To make it easier to work Link to comment Share on other sites More sharing options...
Inony Posted January 31, 2021 Author Share Posted January 31, 2021 Next is the Backpack section. It is the part I redesigned to be able to install VGA. I started with the Light Saber set first. This part has to be very careful. If the screw is too strong A beam from Light Saber may come out and cut off your hand. Then came the installation of a jet engine. Everything is installed in the steel structure. Testing the LED that it works fine. After that take VGA Come and install to check the height , the cover, the power connector, or the anchors that everything is fine. Link to comment Share on other sites More sharing options...
Inony Posted January 31, 2021 Author Share Posted January 31, 2021 Installed to the body. The last step. Plug and Play !!! Finish Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.